Building stone
Building ore, or rock, is one of the principles of cleanliness and cleanliness of the building. In fact, stone is one of the subsidiaries.
The benefits of building stone
The stone is not just for clean and beautifully seen the floor of the building, but the stone is smooth and smooth. They have to ceramic the floor again because of these lines and scratches at the expense and high time from the beginning. The good news of the beautiful team professionally makes all the scratches on the stone professionally stoned, and makes it easy for you to renovate the floor of your building.
Stoning and extending the lifespan of stone
You probably have heard that rocks will increase the life of the stone,
I will tell you in this episode yes this is quite true.
The defective and defective parts of the stone are filled with the same colored resins of your building
This is enough to extend the life of the building stone.
Application of stone
Over time, especially in busy locations such as passages and commercial office centers, rocks are high or darkened and darkened. It is in such cases that the stone service is used and can help improve the appearance and durability of the stone. It also does not matter what kind of stone is the floor, but the stone is done for a variety of surfaces and types of rocks that are injured in busy areas.
In short, stone is used in the following:
What should be considered about stone?
There are many details about the stone service that a skilled skilled specialist is aware of. However, precision to some cases before starting and reviewing them after the process can be reciprocally assisted by the client (customer) and stone. These include:
Check the depth of scratches before subcutaneous
Before starting the rock, the floor force must pay attention to the depths of the scratches on the stone. Over time, the stone may have been damaged and the effects of fractures, cavities or lines and grooves on the stone may be specified. In such circumstances, the skilled specialist should estimate the depth of scratches. If there are some cracks with a depth of one to three mm, these fractures must be repaired before starting the stone process. By repairing fracture, it is no longer necessary to continue the stone submission until the surface of the stone is uniform with fractures created on the stone and the thinner layer will be removed from the stone.
Check the height of the edges after the rock
Collecting effluent simultaneously with subcutaneous operation
Post -resistant should not stay in place for a long time. Because the dryness and tightening of the wastewater makes the stone remain on the stone and last forever (you must have seen examples of this on some stones). Of course, be careful that after collecting the effluent, you should not drain them into the sewage.
Using a three -phase device instead of single phase
If your power meter is three -phase, ask the masters to do the stones with a three -phase device. Because the outcome of the stone is not comparable to the single -phase device and the quality of the work is much higher. In fact, with the help of a three -phase device, the stone will be done in a shorter period of time, better quality and less cost.